Operating instructions

04/08 Application manual Positioning 53
Attention! During the processing of motion blocks and operation modes with elec-
tronic gearing for
Motion Mode 1208, the direction of motion of the
axis may be reversed. The speed defined by the master is too high in
order to reach the target position at the deceleration set in the motion
block. In this case, the target position is passed with the current decel-
eration and then approached from the opposite direction.
V
Deceleration of
motion block 1
Target
Position
Movin
g
to the tar
g
et position
from the opposite direction
Motion block
1
t
Attention! In motion operation modes with electronic gearing the speed override
function is deactivated.
Parameter Master Speed 1129 indicates the speed of the master on the output of
the electronic gear in the operation modes with electronic gear (
Motion Mode
1208).
Note: For more information on the function of the electronic gear, refer to the
chapter "Electronic Gear" and the application manual "Electronic Gear".
Application manual Positioning 5304/08