Operating instructions

04/08 Application manual Positioning 153
Decimal Bit-No. Is set in Motion Mode or Operation Mode
256 8
Gearing.
Parameter
Motion Mode 1208 of the actual motion block is
set to:
− “10 - gearing, absolute” or
− “11 - gearing, relative” or
− “12 - gearing, Touch-Probe: Rising Edge” or
− “13 - gearing, Touch-Probe: Falling Edge” or
− “14 - gearing” or
− “20 - gearing, direct sync., absolute” or
−
“21 - gearing, direct sync., relative” or
− “22 - gearing, direct sync., Touch-Probe: Rising Edge” or
− “23 - gearing, direct sync., Touch-Probe: Falling Edge” or
− “24 - gearing, direct synchronization”
512 9 … 15 The bit will not be set. No function assigned.
Example:
Value 328 decimal is displayed in parameter
Actual Motion Mode 1255.
Status word after conversion from 328 decimal to binary representation:
0 0 0 0 0 0 0 1 0 1 0 0 1 0 0 0
Bit-Numbers of the status word:
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Meaning: Active is a positioning (bit 3) in Motion Mode “gearing (bit 8), Touch-Probe
(bit 6)”.
Note: The status word can be transmitted as signal source “880 - Actual Motion
Mode” via system bus. This requires an expansion module with system bus
interface.
Application manual Positioning 15304/08