Technical data

17
en
Unpacking (1 – 3)
• RemovetheAirWashercarefullyfromthepackaging;
the top assembly is only placed on the bottom base
loosely.
• Usetheoriginalpackagingforstorageifyoudonotuse
theAirWasherthewholeyear.
• Allpackagingcomponentsconsistofenvironmentally
friendlymaterialsandcanbedisposedofwiththe
appropriatelocalwastemanagement.
Positioning (4 – 7)
Checkdataregardingthepowersupplyontheratingplate.
PlacetheAirWasheronthefloororonaflat,drysurface
in the room.
• Theratingplateislocatedontheundersideofthe
bottombase(4).
• Remembertoensureeasyaccessibilityandsufficient
room for servicing and cleaning the Air Washer.
Filling with water (8 – 10)
Onlyfillthewatertankwithfresh,coldtapwater.
Donotpressurizethewatertank,e.g.byfilling
itwithcarbonatedmineralwater.Donotaddes-
sentialoilsorfragrancestothewater;theplastic
material could possibly be discolored or dama-
ged.Closethescrewcapcompletelytoprevent
leakagefromthewatertank.
Putting into operation (11 – 15)
ConnecttheAirWashertothemains(signaltone)andpress
buttonA(12).Thedigitaldisplaycomesonandshowsthe
currenthumidity.TheAirWasherisinNormalmode.
The Air Washer
• operatesespeciallyquietlyinnightmode(PointG,
Symbol«L»Low)
• achievesmaximumhumidityoutput(PointG,
Symbol«H»High)innormalmode
Toswitchoff,pressbuttonA.
A) Switching on/off
PressingbuttonA switchestheapplianceon.Pressingit
again switches the appliance off.Button A isalso used
to start the Cleaning mode. See section «Cleaning mode»
(20–28).
B) Setting humidity level
Theapplianceisfittedwithahygrostat.Thismeasuresthe
relativeairhumidityandautomaticallyswitchestheappli-
anceoffwhenthedesiredvalueisreached.Whenswitching
theuniton,thedesiredvalueispresetto55%.
Thedesiredvaluecanbeadjustedinstepsof5%bypres-
sing button B. While selecting the humidity output, the
desiredvalueisblinking.ThewordDESIREDappearson
thedisplay(F).Thesettingfortherelativehumidityranges
fromaminimumof30%toamaximumof70%relative
humidity or «CO» continous mode. A relative humidity
of between 40 and 60% is recommended. After a few
seconds,the displayautomaticallychanges toshow the
current value (CURRENT) (F). Upon reaching the desired
relative humidity, the unit automatically switches off
(displayshowsDESIREDandCURRENT)(F).Ifthedesired
relativehumidityfalls,theapplianceautomaticallyswitches
on again.
Quick display of current relative humidity
Whentheunitisswitchedoff(mainscableisconnected),
thecurrentrelativehumiditycanbeshowninthedisplay
bybrieflypressingoneoftheBbuttons.Thisdisplayauto-
maticallygoesoutafterafewseconds.
C) Changing the output level
TheAirWashercanbeoperatedontwooutputlevels.
Pressbutton Cto selectbetweenoutput levelsLow «L»
(night-timemode)andHigh«H»(Normalmode).Thechosen
outputlevelisshowninthedisplaybysymbolG.
Operating W490