Product Manual

Page 8 of 13

Parts Diagram

Parts List

Reference

Part Number

Item Description

1500

Caster Fork

4033-1

Caster Wheel Only

4033

Caster Assembly

4035-C

Hardware Kit (not shown)

Assembly Instructions

Place the creeper body decal side-up on a table or the floor. Insert the sixteen 1/4” bolts into the holes

in the body, and then place a piece of tape on each wheel pod to secure the bolts to the body. Flip the

creeper over and slide the casters onto the bolts. Thread the nuts onto the bolts and hand-tighten.

With a 7/16” wrench or socket, carefully tighten the nuts just until the star washer is crushed. If the

bolt spins while you turn the nut, you can use a 3/16” allen wrench to hold the bolt in place.

⚠CAUTION

Over-tightening the nuts will crack the creeper body and void your warranty.

Be sure to occasionally check the tightness of the nuts, as vibrations from rolling can cause them to

gradually loosen.