SDS

Bondo® Rubberized Undercoating 0737 01/30/15
__________________________________________________________________________________________
Page 6 of 15
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing.
Gloves made from the following material(s) are recommended: Fluoroelastomer
Respiratory protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece supplied-air respirator
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
General Physical Form:
Liquid
Specific Physical Form:
Aerosol
Odor, Color, Grade:
Thick black solution with a solvent odor.
Odor threshold
No Data Available
pH
No Data Available
Melting point
No Data Available
Boiling Point
No Data Available
Flash Point
<=0 ºF [Test Method: Closed Cup]
Evaporation rate
>=1 [Ref Std: ETHER=1]
Flammability (solid, gas)
Not Applicable
Flammable Limits(LEL)
1.6 %
Flammable Limits(UEL)
6.5 %
Vapor Pressure
No Data Available
Vapor Density
>=1 [Ref Std: AIR=1]
Density
1.1 g/ml
Specific Gravity
1.1 [Ref Std: WATER=1]
Solubility In Water
Not Applicable
Solubility- non-water
No Data Available
Partition coefficient: n-octanol/ water
No Data Available
Autoignition temperature
>=470 ºF [Test Method: Estimated]
Decomposition temperature
No Data Available
Viscosity
No Data Available
Hazardous Air Pollutants
0.287 lb HAPS/lb solids [Test Method: Calculated]
Volatile Organic Compounds
40.0 % weight [Test Method: calculated per CARB title 2]
Volatile Organic Compounds
440 g/l [Test Method: calculated SCAQMD rule 443.1]
Percent volatile
40.0 % weight
VOC Less H2O & Exempt Solvents
440 g/l [Test Method: calculated SCAQMD rule 443.1]
SECTION 10: Stability and reactivity
10.1. Reactivity
This material may be reactive with certain agents under certain conditions - see the remaining headings in this section.
10.2. Chemical stability