User guide

2. Click the bond shown in the figure.
3. The cursor changes to a bold arrow as you point to the bond.
4. Click the Wedge bond tool.
5. Click each ring bond adjacent to the bold bond.
For each bond, point slightly off center in the direction that you want the wide end of the wedge to be oriented and
click.
Tip: If you move the pointer too far, the highlight box disappears. If placing the pointer is difficult, go to View>Mag-
nify.
Note: If the wedge is pointed in the wrong direction, click the bond again to flip its orientation.
The final structure is:
Tutorial 5: Newman projections
This tutorial demonstrates how to draw a Newman projection of ethane:
ChemBioDraw 13.0
Chapter 6: Tutorials 87 of 401