User guide

Two 35mm Slide Boundary Guides appear in the orientation chosen in the Page Setup dialog box. These guides
appear in every document.
Viewing drawings
Magnification
Magnification changes how large or small your drawing appears without changing its dimensions. You can either
select a value in the magnification dropdown list or enter your own value between 1% and 999%.
Magnify
1. Select an object to keep in view as you magnify the drawing.
Note: If you do not select an object, the last object drawn is the center point of the magnification.
2. Select an option below:
To increase the magnification, go to View>Magnify.
To reduce the magnification, go to View>Reduce.
To return the document to its actual size, go to View>Actual.
To display the whole document, go to View>Show Document.
To set the magnification to a specific value, select or enter a percentage (enter Other between 1-999%) in the
General toolbar.
Rulers
Use the rulers to position objects a measured distance from a reference point or create objects of an approximate
size. To set the ruler units, go to File>Preferences and select the General tab.
Displaying Rulers
To toggle rulers on and off, go to View>Show Rulers.
As you move the pointer, guides appear on each ruler, indicating the position of the pointer.
ChemBioDraw 13.0
Chapter 14: Page layout 283 of 401