Instruction Manual

Multi-Appliance Comfort Control

Page 32

Controls- Installation / Setup / Commissionin

1. Turn the main switch ON to the unit. If the power has already been applied, turn the main switch OFF,

then ON again.

2. Press the ▲ arrow and the ON/OFF button for 5 seconds until the word “CODE” flashes.

3. Code flashes for 15 seconds. When code stops flashing the unit is now ready to turn on.

CHECKING THE SIGNAL – RF REMOTE CONTROL ONLY

There are 3 ways you can check if the wall control is communicating

with unit control board.

1. The red light on the indoor unit control board will flicker when

receiving a signal.

2. The transmission symbol on the control will show for a flash

only. If the symbol hangs for approximately 2 seconds there is

no transmission.

3. Press the MANUAL/AUTO and CLEAN FILTER/ZONE ABCD

for 15 seconds.

• If the 2 dots between the hours and the minutes flash

together signal OK. If the 2 dots alternate there is no

communication.

• Press ENTER in each location to check the signal.

• The test function stays active for 5 minutes after the

last time ENTER is pressed. Where there is no signal,

try re-coding the unit.

CHANGING THE CODE

It is possible for the Code (digital address) to be duplicated in another installation nearby which will

interfere with the successful operation of your unit. To change the code:

1. Turn the system main switch OFF, then ON.

2. Press the HEAT/COOL/FRESH AIR button and the ON/OFF button for 5 seconds until the words

SET CODE and 4 digits show.

3. Each digit can be altered using the ▼ or ▲ buttons. Press ENTER for each digit or digit change.

When all digits have been changed the word CODE will appear briefly until the update has taken

place.

There is a 4 minute window in which to code the unit. Code flashes for 15 seconds. When code stops

flashing the unit is now ready to turn on.