Instruction Manual

Multi-Appliance Comfort Control

Page 17

Ducted Reverse C

cle

USING YOUR COMFORT CONTROLLER – GENERAL OPERATION

There is 2 ways to operate your Comfort Control. You can use MANUAL where you select the operating

modes or you can use the AUTO and program the operation modes to happen automatically.

COOLING MODE - MANUAL

1. Turn the comfort control ON, press and release the ON/OFF

button. When fitted to a Ducted Reverse Cycle system the control

will default to HEATCOOL.

NOTE

: Your Comfort Controller is designed to automatically

detect the appliances you have installed, once coded. Controller

options not required for your appliances will usually not be visible

on your Comfort Control display. So don't worry if you don't see all

the menu items listed in this book.

2. Press the MANUAL/AUTO button until MANUAL is displayed.

3. Press the HEAT/COOL/FRESH AIR button until COOL appears at

the top of the display.

4. Press & hold the ▼ or ▲ buttons to decrease or increase SET

TEMP or, press & release buttons to change the SET TEMP one

degree at a time. Set the temperature to your desired

temperature.

NOTE

: The set temperature must be below the room temperature

before the system will begin cooling operation.

5. The Comfort Control measures the room temperature using a

thermostat inside its case. When the room temperature is warmer

than the SET TEMP the system will start.

NOTE

: For safety operation there is up to a 3 minute delay before

the compressor will start. This safety timer will begin at every

compressor shutdown and when the main switch is first turned on.

6. The indoor fan will operate at the system selected speed; this can

not be changed by the user and has been selected by your

installer to provide you will the most optimum performance for

your system design.

NOTE

: The default fan speed for manual operation is High speed.

7. Press the ON/OFF button to switch the air conditioner OFF. OFF

will appear on the display.

8. The Comfort Control remembers your SET TEMP and operating

setting and uses it next time you turn it ON.