User guide

OWNER’S MANUAL
Home Automation
Page 3
Setup
The interface module has been supplied with a 1 metre comms connection cable.
• Connect the interface module cable into the comms port on the unit control board.
• Connect the Touchpad 20 metre comms Touchpad loom into the plug on the
interface module.
• Connect the home automation wires to the screw terminals as per the wiring diagram
below.
• Connect the 9V AC power pack out put plug to the interface module.
• Plug the 9V AC power pack into a 240-volt supply and power up.
• Power up the Climate Technologies product being interfaced. A red status light will
indicate product signal status through the interface.
• Once the Climate Technologies product has initialised with the Touchpad, use the
home automation device to test turning the product ON or OFF.