Full Product Manual

3
1. General Safety Information
Thank you for purchasing a quality Bonaire Evaporative Portable Cooler. We care about your
safety and would ask you to spend a few minutes reading these simple instructions before
operating this product.
Safety!
Read carefully prior to attempting to assemble, install, operate or maintain the
unit.
- Read and save these instructions. Do not throw these instructions away
- Complete the unit assembly before attempting to operate.
- Interference with and operation of this cooler in any manner not prescribed by these
instructions could cause a safety issue and WILL void any warranty.
WARNING:
- Do not use cooler on uneven or unstable surfaces.
- Do not overfill. Use water only.
- Do not operate cooler with Rear Filter Panel removed.
- Do not insert any foreign objects or body parts into the air inlet or outlet, otherwise
bodily injury or property damage may occur.
- Do not use immediately adjacent to heat sources such as stoves or radiators.
- Do not use immediately adjacent to sources of water, such as swimming pools, hot tubs,
bathtubs, showers, sinks or other liquids.
- Do not operate this product near an open flame or the product may ignite and cause fire,
resulting in bodily injury or property damage.
- Do not operate in areas where gasoline, paint or other flammable liquids or vapours are
used or stored.
WARNING:
- All electrical connections must comply with local construction and safety regulations
and be performed by qualified personnel.
- The power cord should be connected directly to a 120VAC +/-10%, 60 Hz, 1 phase only
grounded GFCI protected electrical receptacle. Make sure that the power switches are in
the off position before connecting and operating your cooler.
- Do not use this product with any solid- state speed control device.
- Keep the cord away from heated surfaces.
- Do not operate cooler with a damaged cord, plug or other components.
- Do not step on or roll over the power cord with heavy or sharp objects.
- Do not run the power cord under carpet or other floor covering. Arrange cord away from
traffic area and where it will not be tripped over.