Technical data

ManualsBrandsBona ManualsBusiness equipmentMiniEdge

Bona AmberSeal

™

Technical data sheet

Rev

/10

This data sheet replaces all previous

versions

page

2/2

Finishing

and prevents the finish from penetrating into the wood surface. Visit www.bona.com for additional

product information.

RECOMMENDED APPLICATORS:

Bona

Floor Coater (T

bar), Bona

Roller, Bona

Cut

In Pad.

NOTE: Use a clean applicator for sealer and a separate clean applicator for finish.

MIXING INSTRUCTIONS:

SHAKE WELL BEFORE USING

–

DO NOT THIN. DO NOT ADD

WATER. Insert supplied filter.

SEALING: 1.

our a 4” wide line of sealer along the starting wall. Go with the grain of the wood.

Using a pre

dampened T

bar sleeve, draw the applicator forward with the grain of the wood,

moving the sealer toward the opposite wall. To maintain a wet edge at all tim

es, hold the applicator

at a snowplow angle.

At the end of each run, turn the applicator towards you and pad out the

applicator parallel to the wet edge.

Feather out all turns. Do not push too hard or too fast to

avoid drips flying off the applicator

. 5.

BE SURE YOU ARE USING THE RECOMMENDED

COVERAGE OF 400

500 SQ. FT. PER GALLON. Uneven coverage can cause blotchiness, or

color variance. Certain species may require a second coat to achieve desired appearance.

Allow

each coat to dry 2

3 hours. High

humidity and/or low temperature conditions will extend the dry

time (recommended conditions of 65

80° F (18°C

27°C) 40

60% relative humidity).

For

smoothest results, abrade before applying finish coats. Always vacuum and tack thoroughly with a

slightly

water dampened Bona Microfiber Mop or cloth after abrading.

INTERCOAT ABRASION:

It is not necessary to abrade AmberSeal unless more than 48 hours has

passed since the previous coat was applied. However, for smoothest results, abrade Bona

AmberSeal with a

Bona

Conditioning Pad and 1

2 Delta sheets as needed or a 150 grit or finer

screen. Always vacuum and tack thoroughly with a slightly water

-dampened Bona Microfiber Mop

or cloth after abrading.

CLEAN

UP:

Application tools s

hould be cleaned with water and stored in an airtight container.

This product has a maximum VOC (Volatile Organic Compound) content of 250 grams per

STORAGE:

Nonflammable

Bona AmberSeal should be stored in a climate

controlled

environment. KEEP FROM FRE

EZING. Do not store above 100° F (38° C).

Item

WB252018003

Size:

1 Gallon

#/Case:

Mainte

nance

Order Information