Technical data

Bona Sport
®
SuperSport
™
Technical data sheet
Rev 11 /10
This data sheet replaces all previous versions page 1/2
The top sport finish for durability and appearance. A premium two - component waterborne wood floor
finish. Specifically formulated for professional use on maple sport floors, providing a tough, high - build
urethane finish.
The most durable sport floor f inish available
Non - yellowing – stays clean and clear even after several recoats
Provides excellent chemical resistance
Protects against perspiration and routine cleaning
Easy to maintain
Available in gloss
MFMA approved
Virtually odorless
Fast drying – Approximately 2 - 3 hours
Nonflammable
Water clean - up
Will adhere to most solvent - based and waterborne finishes and proper preparation, drying, and curing
times
Physical Characteristics:
Ingredients – Water, polyurethane re sin , N- Methyl -2- Pyrrolidone, Dipropylene Glycol Monomethyl Ether
and Dipropylene Glycol n- Butyl Ether
Color – Milky, off white (wet)
pH – 8.3
Solids – 28 %
Viscosity – (#4 Ford cup @ 25 ° C) approx. 16 seconds
Density – 8.52 lbs./gallon (1.0 2 S.G.)
US Re gulatory VOC – 350 g/L
Gloss Level – (60º) 88+
Odor – Non - offending
Stability – 1 year shelf life in unopened container
Packaging – 5 - gallon plastic pail · Comes complete with crosslinker
Application Characteristics:
Clarity – Clear when dry
Leveling – Excellent
Defoaming – Excellent
Drying Time – 2 - 3 hours
Application Tools - Bona
®
Brush, flocked foam Bona
®
Swivel Head Floor Coater, Bona
®
Swedish Roller
Coverage – 500 - 600 square feet per gallon
Percent Cured After 24 Hours – 80%; after 72 hours – 90%
Maximum Cure – 100% in one week
Basketball courts
Volleyball courts
Racquetball , squash and badminton courts
Multi - purpose gym , stage , aerobic and dance floors
BEFORE USING, READ ALL DIREC TIONS AND MATERIAL SAFETY DATA SHEETS.
FOR TECHNICAL ADVICE: Call Bona US at 800 - 872 - 5515
COMPATIBILITY: Bona Super Sport will adhere to most stains, paints, sealers and finishes after proper
preparation and dry times. Stain, sealer, paint and finish res ults may vary widely
depending on the wood species, especially on oily and resinous types. ALWAYS PREPARE A SAMPLE
OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE AND DESIRED RESULTS.
SANDING AND PREPARATION OF NEW FLOORS: 1. Sand and prepare floor us ing MFMA - accepted
methods. 2. Make your final cut with 100 - 120 - grit paper. Screen with 100 - 120 - grit
screen. 3. Vacuum thoroughly. 4. Dry tack thoroughly. 5. Apply sealer and finish system (see finish
directions).
Directions
Technical data
Recommended Use
Finishing