Technical data

Bona Sport
®
Bona SuperSport
™
Seal
Technical data sheet
Rev 11/10
This data sheet replaces all previous versions page 2/2
THE BONA SUPER SPORT SEAL SYSTEM: Bona Super Sport Seal is a 4 coat system: 1 coat of
Bona Super Sport Seal, 1 coat of a Bona waterborne sport floor finish, CourtLines paint (if desired),
and 2 additional Bona waterborne finish coats.
RECOMMENDED APPLICATORS: Light weight T - bar w ith the Bona
®
Floor Coater Sleeve.
NOTE: Use a clean applicator for sealer and a separate clean applicator for finish.
MIXING INSTRUCTIONS: Remove lid and stir thoroughly before using.
FINISHING: 1. Pour a 4” wide line of sealer along the starting wall. Go with the grain of the wood.
2. Using a clean, pre - dampened applicator, draw the applicator forward, with the grain of the wood,
moving the finish toward the opposite wall. Holding the applicator at a “snowplow” angle will
maintain a wet edge at all time s. 3. At the end of each run, turn the applicator toward you and pad
out the applicator parallel to the wet edge. 4. Feather out all turns. If pushed too hard or too fast,
drips will fly off the applicator. 5. Missed areas can be touched up if seen right a way. 6. To prevent
lapping and dry marks, be sure you are using the recommended coverage of 450 - 550 sq.ft.
per gallon. Be careful not to spread the finish too thin. 7. Allow Bona SUPERSPORT SEAL to dry
2- 3 hours. High humidity and/or low temperature condit ions will extend the drying time while
increased ventilation and airflow will reduce dry time (recommended conditions of 65 - 80 °F (18 - 27 °
C), 40 - 60% relative humidity). Apply a Bona waterborne sport floor finish.
INTERCOAT ABRASION FOR FLOORS WITH GAMELINE S: Apply gamelines over the first coat
of finish. Note: DO NOT apply gamelines directly over Bona Super Sport Seal. Before applying
gamelines, abrade with Bona Conditioning Pads or used 150 grit screens and vacuum and tack
thoroughly. IF USING ANOTHER MANU FACTURER’S PAINT, BEFORE APPLYING GAMELINES,
ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATABILITY AND
ADHESION.
INTERCOAT ABRASION FOR FLOORS WITHOUT GAMELINES: It is not necessary to abrade
between Bona waterborne sealer and finish coats unle ss more than 48 hours has passed since the
previous coat was applied. For smoothest results, abrade between all coats as necessary. When
using solvent -based sealers, ALWAYS abrade before finish coats. Always vacuum and tack
thoroughly with a slightly water -dampened Bona Microfiber Mop or cloth after abrading.
CLEAN - UP: Application tools should be cleaned with water and stored in an airtight container.
STORAGE: Nonflammable - Bona Super Sport Seal should be stored in a climat e controlled
environment. KEEP FROM FREEZING. Do not store above 100 ° F (38° C).
Item#: WB200055091
Size: 5 Gallon
#/Case: 1
Order Information
Maintenance
Finishing