Technical data

Bona Remover

™

Technical data sheet

Rev

/11

This data sheet replaces all previous

versions

page

2/2

Coatings

during the initial rinse steps.

11.

Wet tack the entire floor with water. Prior to finish application feel

floor with hand, if floor feels gritty or rough in areas, you hav

e not removed all the Bona Remover.

Repeat steps 9 & 10.

12.

Allow floor to dry and following label instructions apply one coast of Bona

Traffic or Bona Traffic HD. IF A SECOND COAT OF BONA TRAFFIC IS NEEDED, INTER

COAT

ABRASION IS NOT REQUIRED. IF INTER

-C

OAT ABRASION IS NEEDED, ABRADE WITH A 320

GRIT MAROON PAD ONLY. THE BONA RECOAT PROCESS TEMPORARILY WEAKENS THE

FINISH SYSTEM AND AGGRESSIVE ABRASION COULD CAUSE DAMAGE TO TOTAL FINISH

SYSTEM.

Clean

Clean all tools and

equipment with warm water.

Item

WM800018001

#/Case

Order Information

Maintenance