Operating instructions
-- 25 --
Multi Format LCD Monitor
9. Program Update Port(USB)
1) Used for Firmware Update.
9-1 How to update the firmw are by USB port.
Set the Update Execute to Yes, and then, exit the menu by pressing menu button.
Then, it automatically start update procedures.
-Updat e Pr ocess
HOST Updat e : SDI-1, SDI-2 LEDs gradually turn it ON/OFF, and when completed, it starts
Reboot (Approximately 2 minutes required)
VI PER Update : LEDs of below front buttons will be turning as following order, and when
completed, it automatically Reboot.
SDI-1 -> SDI-2 -> CVBS1,2/YC -> YPbPr/RGB -> HDMI -> DVI/VGA.
(Approximately 6 minutes required.)
!
USB Updat e support s HOST/ VI PER Update ONLY.
VI PER Update should be conducted by the update port located in the
rear of the monitor
Good exam ple : In case
proper update file is
located in the inserted
USB
Bad exam ple : In case
Update file is not located
in the inserted USB or NO
USB inserted into the
monitor
1. USB Update File must be located in the priority folder of USB t o execut e update proper ly.
2. USB Update Port support USB storages that w ere Format ed by FAT12,FAT16
or FAT32 file system ONLY.
3. A few of USB storages may not be recognized in BXM Monit or.
!
I f Monit or does not recognize USB proper ly, inser t USB storage ahead of time before
Turn the monitor ON.
!