User manual

MAINTENANCE
While reading this Operator’s Guide, remember that:

WARNING
Indicates a potential hazard that, if not avoided, could result in serious in-
jury or death.

WARNING
Unless otherwise specified, engine
should not be running for all main-
tenance procedures.
Before performing any service or
inspection operation on the vehi-
cle, wait until the engine and ex-
haust have cooled down to avoid
getting burned.

WARNING
Should removal of a locking de-
vice (e.g. lock tabs, self-locking
fasteners, etc.) be required when
undergoing disassembly/assem-
bly, always replace with a new
one.
The following covers the maintenance
items that can be performed by the
customer if desired. Other items
found in maintenance chart must be
performed by an authorized Bom-
bardier ATV dealer.
NOTE: Among other things, this sec-
tion gives the procedures to replace
the liquids. Refer to LIQUIDS for pro-
cedures to check levels and refill.
Engine/Transmission
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.

WARNING
The engine oil can be very hot. In
order to avoid getting burned, do
not remove the engine drain plug
or the filter cover if the engine is
hot. Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
V07C03Y
1
TYPICAL
1. Oil drain plug
Allow enough time for oil to flow out
of oil filter.
Remove the right engine cover.
Unscrew the oil filter cover.
_____________________
95