Specifications

General Inspection
Check electrical wiring and cOf!1po-
nents, retighten loose connections.
~heck. for stripped wires or damaged
insulation. Thoroughly inspect the ve-
hicle and tighten loose bolts, nuts and
Bulb Replacement
If the headlamp is burnt, tilt hood and
unplug the connector from the head-
lamp. Remove the rubber boot and un-
fasten the bulb retainer Detach
the bulb and If taillight
bulb. is burnt, expose the bulb by
moving the red plastic lens. (Two (2)
Phillips head screws). Verify all lights
after replacement.
20
STORAGE
.... WARNING: Only perform such
T procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components / systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for
all lubrication and maintenance pro-
cedures.
Track
the track for wear, cuts, miss-
ing track guides and broken rods.
Make any necessary replacement.
.... WARNING: Do not operate a
T snowmobile with a cut, torn or
damage track.
Lift the rear of the vehicle until the
track is clear of the ground, then
sup-
port it with a brace or trestle. The
snowmobile should be stored
in such a
way that the track does not stay in
contact
with the ground.
O
NOTE: The track should be rota-
ted periodicallyI (every 40 days).
Do
not release track tension .
.. CAUTION: To prevent track
.. damage, temperature in the stor-
age area must not exceed 38° C
(lOO°F).