Specifications

"shut-off" is re-
pull cap from
will be auto-
device turn nut
In re-
J) Tether Cut-Out Switch
Attach tether cord to wrist or other
convenient location then snap tether
cut-out over before
Hood Removal
Unlatch cap by turning both handles
toward front of vehicle, remove fuel
tank cap, gentlv
lift hood then discon-
nect junction block at right side of en-
gine. Remove hood from vehicle.
A WARNING: It is dangerous to run
.... engine with cab off. Personal in-
jury could result.
Seat Compartment
Remove backrest and tilt seat. Ideal
location for spare plugs, belt, rope, etc.
O
NOTE: Emergency materials
should be wrapped in foam or
similar material. This will prevent pos-
sible damage to breakable items when
travelling over rough or bumpy terrain.
Fuel Gauge
Unscrew fuel tank cap and withdraw
dipstick to check fuel level.
A WARNING: Never use a lit match
.... or open flame to check fuel level.
If erneroencv
quired
switch and
rYl':lt'r"·:lIl\J shut
O
NOTE: The cap must be installed
on the switch at all times in
order to operate vehicle.
A WARNING: If the switch is used
.... in an emergency situation the
source of malfunction should be
de-
termined and corrected before restart-
ing engine.
H) Gear Shift Lever
A 2 position, (FORWARD / REVERSE)
gear shift lever. Push up for forward
and
down for reverse.
.. CAUTION: Do not activate gear
.... shift lever while snowmobile is in
motion.
O
NOTE: When a disabled
VV"fl.J"~. its drive belt must be re-
moved from and the gear shift
lever into forward gear.
I) Access Door Latch
To gain access to the carburetor or
spark plugs,
lift lock tab and
pull open access
The driver of this vehicle should fami-
liarized himself
with the function of this
device by using it several times on first
outing. Thereby being mentally pre-
pared for emergency situations requiring
its use.
A WARNING: If the switch has been
.... used in an emergency situation
the source of malfunction should be
determined and corrected before re-
starting engine.
F) Manual Starter Handle
Auto rewind type located on hand
side of vehicle. To engage
pull handle.
G) Primer
A push-pull button. Pull and push but-
ton (2-3 times) to activate primer. The
should be used for cold
starts. After is warm
it is not necessary to use
mer when
"t",r+.r,,-.,
7