Specifications

Reassemble entire bogie wheel set,
making sure assembly moves freely.
Reinstall bogie wheel set. Repeat
above steps on remaining bogie wheel
sets. Lubricate rear hubs through
grease fittings.
Ski Assembly
Wash or brush all dirt or rust accumu-
lation from ski and spring. Grease ski
leg at grease fitting. Check condition
of ski and ski runner. Replace if
worn
or weak. Apply metal protector on ski
assembly. If unavailable, wipe the
entire ski with a
doth soaked in oil to
prevent rust formation.
Fuel Tank and Carburetor
Remove cap the using a syphon, re-
move gasoline from tank .
•
WARNING: Gasoline is flamma-
ble and explosive under certain
conditions. Always manipulate in a
well ventilated area. Do not smoke or
allow open flames or sparks in the vici-
nity.
The carburetor must be dried out com-
pletely to prevent gum formation dur-
ing the storage period.
Assure that carburetor inlet fuel line is
disconnected. Remove plug of the
float chamber. Drain carburetor.
Reinstall plug and connect fuel line.
Check all fuel lines. if neces-
sary.
22
Cylinder Lubrication
Engine internal parts must be lubri-
cated to protect cylinder walls from
possible rust formation during the
storage period.
O
NOTE: This operation should be
repeated every 40 days during
storage.
Remove spark plugs, operate rewind
starter to bring piston at top position.
Pour the equivalent of one spoonful of
oil into spark plug hole.
Slowly crank engine several times
using manual starter. Repeat above
for other cylinder. Install spark
plugs.
.., CAUTION: To prevent ignition
.... system damage, make sure that
the cut-out
button is in the lower posi-
tion.
Gearbox
Drain gearbox and refill with 454 mL
(16 oz) of fresh Bombardier chaincase
oil. (Drain plug is located beneath
frame).