Specifications
Drive Pulley
Inspect the Duralon bushing condition
by checking the free-play of the sliding
half pulley. This is achieved by restrain-
ing the inner half and checking if the
sliding half moves in the direction of
the arrows more than
3 mm
(1/B").
If
so contact your dealer.
Mark reference
point
on
both
halves
Maximum
3 mm
Brake
The brake mechanism is self-adjusting,
therefore, periodic adjustment is not
required. However, the brake mecha-
nism can be checked by depressing
brake control lever. Brake should apply
fully when lever is 13 mm
(1I2")
ap-
prox. from handlebar grip. If it does
not, do not tamper
with
the brake,
contact your servicing dealer. Check
the stop
light to see if it functions. If
necessary, readjust switch position .
.&.
WARNING:
Brake pucks less
T than 5 mm
(3/16")
thick must be
replaced. Replacement must be per-
formed by an authorized Bombardier
dealer. Always check the stop light to
see if it functions.
Steering Adjustment
Ski should be perpendicular to handle-
bar. To align:
Remove padding.
Remove bolt securing handlebar to
steering column.
Remove handlebar to expose splined
end of steering column.
20
Reposition handlebar on splines so that
it is perpendicular
with
ski. Install and
tighten bolt to 40-47
N.m
(30-35 ft-Ibsl.
O
NOTE: If correct spline alignment
is unobtainable at handlebar,
move lower steering bracket (located
on
top
of gearbox) to obtain proper lo-
cation. Lower steering bracket
holes
are slotted.
Engine
Head
Nuts
IMPORTANT: The engine head
nut
tor-
que should be checked after the first
5
hours of operation.
With
engine cold, check that engine
head nuts are
tight
and equally torqued
to
20 N.m (15 ft-lbs).
Engine
Mount
nuts
Check engine
mount
nuts for tight-
ness. Retighten if necessary.
Muffler
Attachment
The" engine / muffler attaching parts
are vital toward efficient muffler func-
tion. Check
all attachments. Replace
springs and / or tighten if necessary.
Fan Belt
Inspect belt
for
cracks, uneven wear,
etc. Check fan belt tension, 6 mm
(:4
")
free-play should exist when deflection
is correct.
If belt seems damaged or if tension is
incorrect, contact your dealer immedi-
ately.
.&.
WARNING:
If fan protector is re-
T moved, always reinstall after ser-
vicing.