Specifications

aoa:::u......,'O q;;z::::c:<
/
To grease the inner side bogie wheels,
tut vehicle on its side and apply pres-
sure on track to expose grease fittings.
ReairAxles
Lubricate the rear axles with low-tem-
perature grease. Pump grease through
the rear axle fittings.
.. CAUTION: Always use a low-
". pressuregrease gun.
Bogie Wheels
Grease the suspension bogie wheels
with low-temperature grease. Pump
through the grease fitting at the center
of each wheel until new grease appears
at the
joint of inner side.
To fill, remove filler cap from top of
gearbox. Refill as required using
Bom-
bardier chaincase oil.
check oil level. Oil level must reach 82
mm
(314 It) on dipstick.
Grease the ski leg at grease fitting until
new grease appears at the joint. Lu-
bricate spring coupler bolt
with oil.
Gearbox Oil Level
The gearbox oil capacity is 454 mL (16
oz). To check level:
Remove rubber inspection cover lo-
cated on
bottom right side of gearbox.
Using a rigid piece of wire as dipstick,
Driven Pulley
With hood removed, grease the driven
pulley shaft as follows:
Remove pulley guard and slip
off drive
belt. Open the driven pulley, (push and
twist sliding half).
Thoroughly clean the driven pulley
shaft.
Apply a light coat
of low-temp grease
on the shaft. Always lubricate lightly
and wipe
off surplus.
O
NOTE: Activate the sliding half
several times to distribute lubri-
cant over full length of shaft. Be care-
ful that lubricant does not get on inner
halves of pulley.
Steering Mechanism
Using light machine oil, lubricate the
spring located on top of steering
col-
umn housing. Allow oil to run in. Oil the
mobile contact point at bottom end of
steering arm. Using a small brush,
dipped in
low temp grease, lubricate
steering arm ball joint.
15