Specifications

DRIVING TIPS
Bogie Wheel
By raising the outer attachment of the
bogie wheel sets! vehicle maneuver-
ability in deep
snow will increase. You
will note that there are partially drilled
holes located approx. 3.5 cm
(1 0/8 ")
above the original cross shaft holes of
the frame. To reposition bogie wheel
sets, drill holes fully through using a
5/
16
/1 dia. drill. Remove capscrews se-
curing bogie wheel cross shafts to
frame and reinstall bogie wheels in new
position.
Front Hood Louvers
When operating the vehicle in powder
snow it is advisable to block the front
hood louvers as per illustration. Un-
block the louvers as soon as snow con-
dition becomes firmer or as soon as en-
gine becomes too hot.
Air Silencer Box
... CAUTION: Never operate your
.. snowmobile with the air silencer
tube disconnected. Serious engine
damage will occur if this notice is
disregarded.
When operating the vehicle in temper-
ature exceeding
ooe l32°F), the rubber
plug must
block the engine side orifice
and the rubber vent must be positioned
on the side of the silencer box to allow
cold air circulation.
In temperatures below 0°
e (32° F)
and/ or powder snow, the rubber plug
must block the entry of fresh air on the
side of the silencer box and the rubber
vent must allow the warm air being
emitted from the engine to be directed
over the carburetor.
.., CAUTION: Observe temperature
.. changes and locate plugs accord-
ingly. Incorrect location of plugs may
cause carburetor ice-up or engine over-
heating.
13