HOUSEHOLD VENTED TUMBLE DRYER WT 5019 Instruction Manual
Contents Introduction ……………………..………………….………………………………………………….….... Page 3 General Notes …...……………………………………….……………………………………………..…. Page 3 Special safety Information for this Unit ……………………………...…………………………….......... Page 4 Unpacking the Appliance …...………………………………..…………………………………………… Page 5 Appliance Equipment ……………………..….………………………………………………………….... Page 5 Installation …...…………………………………………………………………………………………..…. Page 6 Startup / Operation ……………………..………………………………………..…………………..........
and disconnect the plug (pull the plug itself, not Introduction the lead) or turn off the fuse. Thank you for choosing our product. We hope you • The appliance and if possible the mains lead have will enjoy using the appliance. to be checked regularly for signs of damage. If damage is found the appliance must not be used. Symbols in these Instructions for Use • For safety reasons, alterations or modifications of Important information for your safety is specially the appliance are prohibited.
Special safety information for this Unit WARNING: Hot surface! Danger Danger of burns! The touchable surfaces may become very hot during operation. WARNING WARNING: NING: Never switch the appliance off before the end of the drying cycle, unless all washing is taken out quickly and spread out so that the heat can be dissipated. • The dry weight of laundry must not exceed the max. capacity of 6 kg.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. • Children under 3 years should be kept away, unless they are constantly supervised. • Children shall not play with the appliance.
The most common cause of overheating is a clogged - at locations with high humidity (e.g. outdoors), lint filter and blocked vents. as metal parts would be susceptible to corro- Once the circuit breaker tripped, the appliance is not sion under such circumstances; - heating. Proceed as follows: - Switch off the appliance, - wait about 10 minutes before you restart the op- 5°C or above 35°C. Do not expose the appliance any weather. - eration, and after correcting the cause.
Electrical connection • Connect the mains cable to a properly installed and earthed wall outlet. WARNING: • If the plug after installation is not accessible, a • The installation to the mains supply must conform corresponding disconnect device must be availa- to the local standards and regulations. ble to meet the relevant safety regulations. • Improper connection may cause to an electric shock! shock • Do not use multiple sockets or extension cords.
• Softeners or similar products should be used as specified in the softener instructions. • Remove all objects from pockets, such as matches and lighters. • Close zips, buttons, or hooks before drying. Tie loose straps or loops together. The control lamp indicates the activation. Adding laundry When activated, all controls, except the power • Shake out the washed fabrics and sort them ac- button, are disabled for operation.
Starting a Program Program table NOTE: NOTE: The figures listed below are approximate figures and recommendations under normal operating conditions and are therefore for information only. The program running times and the consumption data may deviate from the specified figures according to load, remaining moisture, and temperature. Pro Program Drying level Program selection Loading Loading Remaining Time Ener Energy information (dry weight) weight) moisture Min Min kWh 160 5.23 100 3.
programs, except in the time controlled program • Leave the appliance door slightly open until the [60 MIN]. next dry cycle to avoid odors. • If the appliance is not in use for an extended time: Capacity - Do not overload the appliance, otherwise the fabrics disconnect it from the power supply! Energy saving tips will become stretched and drying will be impaired. Refer to the information in the "Program table". • Take advantage of the maximum capacity of each dry program.
• Check the drum regularly on dirt or fiber residues; Error messages With some malfunctions the appliance indicates the with a soft, damp cloth. following error codes to warn you: Cleaning the lint filter E1 CAUTION: CAUTION: • Dirty filter affect the drying result. Check and Control Reason Action [Leicht] NTC or PCB fault See “Over- installed filter. Improper insertion of filter may afE4 fect the performance and damage the appliance.
Disposal Meaning of the “Dustbin” Symbol Protect our environment; do not dispose of electrical equipment in the domestic waste. Please return any electrical equipment that you will no longer use to the collection points provided for their disposal. This helps avoid the potential effects of incorrect disposal on the environment and human health. This will contribute to the recycling and other forms of reutilization of electrical and electronic equipment.
EU Product Data Sheet Product information for household tumble dryer according to regu regulation (EU) No. 392/2012 Brand BOMANN Model WT 5019 Rated capacity capacity kg Dryer type Air vented Energy efficiency Annual energy 6 class1) C consumption2) kWh/a 452 Automatic tumble dryer ∙ Energy consumption standard program - with full load kWh 3.81 - with partial load kWh 2.05 Power consumption: off mode W 0.46 Power consumption: left-on mode W 0.
www.bomann.de Made in P.R.C. 16 Stand 11/17 C.
