Operation Manual

19
Cleaning
CleaningCleaning
Cleaning and Maintenance
and Maintenanceand Maintenance
and Maintenance
WARNING:
WARNING:WARNING:
WARNING:
• Always switch off and disconnect the appliance
from the power supply before cleaning and user
maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock!
Risk of electric shock!Risk of electric shock!
Risk of electric shock! Hot steam could damage
the plastic parts.
• The appliance must be dry before restarting oper-
ation.
CAUTION:
CAUTION:CAUTION:
CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Cleaning the appliance including interiorCleaning the appliance including interior
Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting
DefrostingDefrosting
Defrosting
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate.
Make sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
Lighting
LightingLighting
Lighting
CAUTION:
CAUTION:CAUTION:
CAUTION:
Do NOT
NOTNOT
NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.
Troubleshooting
TroubleshootingTroubleshooting
Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialistBefore you contact an authorized specialist
Before you contact an authorized specialist
Problem
ProblemProblem
Problem Cause / Action
Cause / ActionCause / Action
Cause / Action
Appliance is
not working
or not
properly
- Insert the power plug correctly or
check the fuse.
- Check the temperature setting.
- Check the ambient temperature.
- Unblock the ventilation openings,
install the appliance freely.
Stored food
is too warm
- Check the temperature setting.
- Open the door only as long as neces-
sary.
- Check the location.
Loud noise
during oper-
ation
- Check the appliance position.
- See the section “Operating noise”.
Problem
ProblemProblem
Problem Cause
CauseCause
Cause / Action
/ Action/ Action
/ Action
Water on the
appliance
bottom
- Check the temperature setting.
- Clean the water discharge channel /
opening.
Interior light
is not work-
ing
- Insert the power plug correctly or
check the fuse.
- See the section “Lighting”.
Water on the
outer sur-
face.
On days of high humidity, condensation
might occur on the outer surface of the
appliance. No malfunction!
NOTE:
NOTE:NOTE:
NOTE:
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.