User Manual HOUSEHOLDREFRIGERATOR WITH ICE BOX KS 263 Please read this manual carefully and keep for future reference! 1 11/2012
TABLE OF CONTENT OVERVIEW DISPOSAL OF USED DEVICES IMPORTANT USE AND SAFETY INSTRUCTIONS General Safety Precautions Coolant Intended Use PRODUT DESCRIPTION Delivery Scope Specifications INSTALLATION Location Electrical Requirements REVERSE THE DOOR OPENING STARTUP / OPERATION Prior to First Use Operation Turning off TIPS FOR SAVING ENERGY MAINTENANCE AND CLEANING Cleaning and Care Reverse the Bulb Repairs 2 2 3 3 3 3 4 4 4 5 5 5 6 6 6 6 7 7 8 8 8 8 OVERVIEW Please read this user manual thoroughly before f
IMPORTANT USE AND SAFETY INSTRUCTIONS General Safety Precautions All safety information in this user manual are marked with a warning symbol. They indicate possible dangers precociously. It is imperative to read and follow these information. - Do not touch the plug at the mains cable with wet or moist hands when connecting or disconnecting. Risk of death by electric shock! In case of emergency, unplug the device immediately. Hold the plug when disconnecting the mains cable; do not pull the cable.
IMPORTANT: Make sure you dispose of packaging materials environmentally friendly. Removing the Transport Protection The device and parts of the interior are protected for transport. Remove all adhesive tapes from the right and left side of the door. You may remove adhesive residue with a cleaning solvent. Also remove any adhesive tapes and packaging materials from the inside of the device.
INSTALLATION Location Sufficient ventilation around the device is necessary in order for the heat to dissipate properly and to guarantee efficient cooling operation at low power consumption. For this purpose, leave sufficient space around the device. - Minimum clearance of 5 cm between rear side and wall, - at least also 5 cm at both sides and on top of the device. - Leave proper space in front of the device in order to open the door at an angle of 160°.
REVERSE THE DOOR OPENING If required, the door opening can be moved from the right (supplied condition) to the left side. WARNING When replacing the door stop, the device must be disconnected from the power supply. Always unplug the device first. 1. Use a small flat screwdriver to lift up the two screw covers (1) on the top cover (3). 2. Use a cross screwdriver to remove the two screws (2) on the top cover and the other two screws (11) on the backside of top cover. 3.
Turning the temperature control clockwise will lower the inside temperature. Please keep in mind that the temperature changes with the ambient temperature (of the location), with the frequency of opening the door and the amount of food in the device. During initial operation, turn the temperature control to the highest setting first, until the device has reached the desired operating temperature.
- Allow warm dishes to cool down before putting them in the device. Do not open the door longer then necessary. Only set the temperature as low as needed. The ideal temperature in the fridge is 7°C. It should be measured in the upper shelf, as far as possible in the front. The device should be defrosted regularly. Make sure the door sealing is in good order for the door to close properly. MAINTENANCE AND CLEANING Cleaning and Care For hygienic reasons, clean the interior and accessory parts regularly.
Water on the Is the temperature control set properly? bottom Check the temperature settings. Interior lamp Is the plug not connected to the mains? Connect the plug properly to the socket, turn on does not work Has the safety mechanism of the wall socket the fuse, and contact a technician if necessary. been triggered? Disconnect the plug and replace the illuminant Is the illuminant defect? (refer to ‘Replacing the bulb’).
