User Manual HOUSEHOLDREFRIGERATOR KS 193 Please read this manual carefully and keep for future reference! 1 01/2012
TABLE OF CONTENT OVERVIEW DISPOSAL OF USED DEVICES IMPORTANT USE AND SAFETY INSTRUCTIONS General safety precautions Risk of injury Coolant Intended use Unpacking PRODUT DESCRIPTION Delivery scope Specifications INSTALLATION Location Electrical connection REVERSE THE DOOR OPENING STARTUP / OPERATION Prior to first use Turning on Storing food Defrosting Operating noise Turning off TIPS FOR SAVING ENERGY MAINTENANCE AND CLEANING Cleaning and care Reverse the bulb Repairs What if . . .
This will prevent children from locking themselves (risk of suffocation!) or from getting into perilous situations. Children might not understand the risks that arise from handling household devices. Therefore, observe children and make sure they do not play with the device. IMPORTANT USE AND SAFETY INSTRUCTIONS General safety precautions All safety information in this user manual are marked with a warning symbol. They indicate possible dangers precociously.
Unpacking The packaging must be undamaged. Check the device for any possible transport damage. Do not install a damaged device. In case of damage, please contact your distributor. ATTENTION Remove the separate polystyrene part (transport protection) between the rear of the device and condenser – metal grid (if available). Packaging material The packaging for transportation of the device and individual parts is produced of recyclable materials.
(1) A+++ (highest Efficiency) up to G (lowest Efficiency) Climate class SN (Subnormal): ambient temperature of +10°C up to +32 C Climate class N (Normal): ambient temperature of +16 C up to +32 C Climate class ST (Subtropics): ambient temperature of +16 C up to +38 C Climate class T (Tropics): ambient temperature of +16 C up to +43 C (3) The actual energy consumption depends on the use and installation of the device.
REVERSE THE DOOR OPENING If required, the door opening can be moved from the right (supplied condition) to the left side. WARNING When replacing the door stop, the device must be disconnected from the power supply. Always unplug the device first. 6. 7. 8. 9. 1. Use a screw-driver to remove the screw covers (11) at the device top cover. Unscrew the below screws (10) and remove the device cover (9). 2. Put the blind cap (8) of the device top cover (9) at the opposite side. 3.
Connect the device to the mains supply IMPORTANT • The device must be earthed properly. For this purpose the plug of the mains cable has been fitted with the intended lead. • Contact an electrician if the plug does not fit in the wall socket. • In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting the device.
• Frozen food should be kept in contact with the bottom of the compartment. • Keep a space between the single items for air circulation. Storing frozen food • Packed frozen merchandise should be stored in a 4-star-freezer compartment in accordance with the manufacturer’s data. Make sure the food items do not defrost after purchase and to store them as fast as possible in the freezer. • It is possible to store food for longer periods of time, up to three months.
• • • • Turn the temperature control to setting 0 - OFF. Disconnect the plug or turn off / unscrew the fuse. Thoroughly clean the device (refer to chapter of “Cleaning and Care”). Keep the door open in order to prevent bad odors. TIPS FOR ENERGY SAVING • Disconnect the plug if you do not use the device. • Do not install the device near stoves, heaters or other heat sources. In case of higher ambient temperatures, the compressor will run more frequently and longer.
Repairs WARNING Servicing of electric devices must be conducted by qualified experts only. Incorrect or improper repairs constitute a risk for the user and will void the warranty! What if . . . Troubleshooting The design of the device ensures a trouble-free operation as well as a long life cycle. Nevertheless, if any defect occurs during operation, please check if it is caused by improper operation. The following problems can be solved by you by checking for the possible cause.
