Operation Manual

•
Before connecting, ensure that the power supply
corresponds with the information on the rating l
bel (appliance back)
and the wiring diagram.
•
The appliance is suitable for three
current ( 220-240/380-415V 3N~
50
•
The appliance can be adjusted for single
current by a respective bypass on the terminal
block,
based on the circuit diagram below. Select
a suitable cord as main
s cable, considering the
connection type and nominal power of the oven.
•
Fix the mains cable in the tension relief.
•
Make sure to connect the protective ground to the
terminal of
the marked terminal block.
•
The electrical installation of the oven should be
equipped with an emergency switch, which
switches off the whole appliance from the mains
supply in an emergency. The distance between
the contacts of the emergency switch must be at
least 3 mm.
•
Arrange the mains cable in such a way that it
does not get in
contact with any hot components
of the appliance. Do not lead it over sharp edges
or corners.
Connection wiring diagram
Connection wiring diagramConnection wiring diagram
Connection wiring diagram
Permissible connection methods
Permissible connection methodsPermissible connection methods
Permissible connection methods
CAUTION:
CAUTION:CAUTION:
CAUTION:
Each connection requires the protective ground of the
mains to be connected to the E
terminal.
NOTE
NOTENOTE
NOTE:
::
:
L1, L2, L3 = Phase
N = Neutral
E = Protective ground
380-415V 3N~ 50Hz 380-
415V 2N~ 50
H05 VV-F 5G 1.5mm² H05 VV-
F 4G 1.5mm²
7
Before connecting, ensure that the power supply
corresponds with the information on the rating l
a-
and the wiring diagram.
The appliance is suitable for three
-phase and AC
50
Hz ).
The appliance can be adjusted for single
-phase
current by a respective bypass on the terminal
based on the circuit diagram below. Select
s cable, considering the
connection type and nominal power of the oven.
Fix the mains cable in the tension relief.
Make sure to connect the protective ground to the
the marked terminal block.
The electrical installation of the oven should be
equipped with an emergency switch, which
switches off the whole appliance from the mains
supply in an emergency. The distance between
the contacts of the emergency switch must be at
Arrange the mains cable in such a way that it
contact with any hot components
of the appliance. Do not lead it over sharp edges
Each connection requires the protective ground of the
terminal.
415V 2N~ 50
Hz
F 4G 1.5mm²
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
Before initial use
Before initial useBefore initial use
Before initial use
•
Clean the oven interior with all therein located
accessories. Follow the instructions that we give
you in the chapter "Cleaning and Maintenance".
•
In order to burn any manufacturing residue, h
the closed oven for approx. 4
Use the
heating function [Upper/lower heat
Then switch to the heating function [Grill] for a
other 20 minutes.
NOTE
NOTENOTE
NOTE:
: :
:
The occurring odor and possibly a slight smoke
development cannot be avoided. Therefore e
sure for a good ventilation of the room during
heating.
Operation
OperationOperation
Operation
1
11
1
Level regulator of cooking zones
Level regulator of cooking zonesLevel regulator of cooking zones
Level regulator of cooking zones
The temperature setting is
set for each cooking zone
separately by using the
respective level regulator.
CAUTION: Depending on
CAUTION: Depending on CAUTION: Depending on
CAUTION: Depending on
Turn the level regulator of the double
roasting tin
zone only clockwise and back again.
Otherwise the switch will be damaged.
= Position of cooking zone
0
00
0 = Off-position
1
11
1
= Lowest setting (keep food warm)
6
66
6 = Model EHC 3557
= Model EHC 3557= Model EHC 3557
= Model EHC 3557
9
99
9 = Model
= Model= Model
= Model EHC 3558
EHC 3558EHC 3558
EHC 3558
Highest setting (quick
heating and cooking,
roasting)
2
22
2
Cooking zone power control lamp
Cooking zone power control lampCooking zone power control lamp
Cooking zone power control lamp
The power control lamp indicates the operation of the
cooking zones. It lights up as soon as a cooking zone
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
Clean the oven interior with all therein located
accessories. Follow the instructions that we give
you in the chapter "Cleaning and Maintenance".
In order to burn any manufacturing residue, h
eat
the closed oven for approx. 4
0 minutes at 200°C.
heating function [Upper/lower heat
ing].
Then switch to the heating function [Grill] for a
n-
The occurring odor and possibly a slight smoke
development cannot be avoided. Therefore e
n-
sure for a good ventilation of the room during
Level regulator of cooking zones
Level regulator of cooking zonesLevel regulator of cooking zones
Level regulator of cooking zones
set for each cooking zone
respective level regulator.
CAUTION: Depending on
CAUTION: Depending on CAUTION: Depending on
CAUTION: Depending on
model!
model!model!
model!
Turn the level regulator of the double
cooking and
zone only clockwise and back again.
Otherwise the switch will be damaged.
= Position of cooking zone
= Lowest setting (keep food warm)
Highest setting (quick
heating and cooking,
roasting)
Cooking zone power control lamp
Cooking zone power control lampCooking zone power control lamp
Cooking zone power control lamp
The power control lamp indicates the operation of the
cooking zones. It lights up as soon as a cooking zone