Operation Manual

9
Installing the cooker
 The kitchen area should be dry and aired and equipped with efficient ventillation. When
installing the cooker, easy access to all control elements should be ensured.
 This is a Y–type design built–in cooker, which means that its back wall and one side wall
can be placed next to a high piece of furniture or a wall. Coating or veneer used on fitted
furniture must be applied with a heat–resistant adhesive (100°C). This prevents surface
deformation or detachment of the coating.
 Hoods should be installed according to the manufacturer’s instructions.
INSTALLATION
1 Assembly of electric hob with brackets:
 make an opening with the dimensions given in the diagram for the hob to be mounted on
the worktop;
 Check seal for perfect fit and overal cover. Lower the electric hob into place andalign
correctly.
 Tithten bracket against the underside of the worktop.
 Using a standart screwdriver, tighten the tension clamps evenly starting at the centre and
moving diagonall, until the built-in rim is tight on the worktop.
560
490
min
50
139
120
139
120
1 - worktop
2 - screw
3 - bracket
4 - electric hob
5 - hob seal
5 4
321
5 4
32
1