Operation Manual

•
Use a soft absorbent cloth for drying afte
ing.
Cleaning the glass panel
Cleaning the glass panelCleaning the glass panel
Cleaning the glass panel
If necessary, clean the inside of the glass pane
• Open the oven door.
• Remove the supports by
loosening the screws lateral-
ly of the supports.
• Take off the glass carefully
forward.
•
Replace the glass panel and fasten
after you’
ve cleaned the glass and dried
oughly.
Reverse the bulb
Reverse the bulbReverse the bulb
Reverse the bulb
WARNING:
WARNING:WARNING:
WARNING:
•
Make sure that the appliance is turned off from
the power supply (fuse).
•
Allow the lamp to cool down before replacing the
bulb. There is risk of burns!
There is risk of burns!There is risk of burns!
There is risk of burns!
NO
NONO
NOTE
TETE
TE:
::
:
Use the correct bulb, heat resistant up to 300°C:
1 x 25 W (type G
1 x 25 W (type G1 x 25 W (type G
1 x 25 W (type G9)
9)9)
9)
• Unscrew the lamp cover anti-
clockwise and clean
it with a dry cloth.
• Change the bulb.
• Reattach the
lamp cover and screw it
tight in a clockwise direction.
• Check the functionality.
9
Use a soft absorbent cloth for drying afte
r clean-
If necessary, clean the inside of the glass pane
l.
forward.
Replace the glass panel and fasten
the supports
ve cleaned the glass and dried
it thor-
Make sure that the appliance is turned off from
Allow the lamp to cool down before replacing the
Use the correct bulb, heat resistant up to 300°C:
clockwise and clean
lamp cover and screw it
Trou
TrouTrou
Trou
bleshooting
bleshootingbleshooting
bleshooting
Before you contact an
Before you contact an Before you contact an
Before you contact an
authorized specialist
authorized specialistauthorized specialist
authorized specialist
Problem
ProblemProblem
Problem
Possible causes
Possible causesPossible causes
Possible causes
Appliance
does not
work.
The power supply
is
disconnected.
The oven
lamp does
not work.
The bulb is defe
tive,
has been
inserted incorrectly
or not firmly.
NOTE:
NOTE:NOTE:
NOTE:
If a problem still persists after following the steps
above, contact your distributor or an authorized tec
nician.
bleshooting
bleshootingbleshooting
bleshooting
authorized specialist
authorized specialistauthorized specialist
authorized specialist
Possible causes
Possible causesPossible causes
Possible causes
What to do
What to doWhat to do
What to do
The power supply
disconnected.
Check the fuse
of your domestic
wiring system.
The bulb is defe
c-
has been
inserted incorrectly
Check the bulb,
see “Reverse
the bulb”.
If a problem still persists after following the steps
above, contact your distributor or an authorized tec
h-