CERAMIC HOB EBK 957.
Contents Introduction ……………………..………………….………………………………………………….….... Page 3 General Notes …...……………………………………….……………………………………………..…. Page 3 Special safety Information for this Unit ……………………………...…………………………….......... Page 4 Unpacking the Appliance …...………………………………..…………………………………………… Page 5 Appliance Equipment ……………………..….………………………………………………………….... Page 6 Installation …...…………………………………………………………………………………………..…. Page 6 Startup / Operation ……………………..………………………………………..…………………..........
and disconnect the plug (pull the plug itself, not Introduction the lead) or turn off the fuse. Thank you for choosing our product. We hope you • The appliance and if possible the mains lead have will enjoy using the appliance. to be checked regularly for signs of damage. If damage is found the appliance must not be used. Symbols in these Instructions for Use • For safety reasons, alterations or modifications of Important information for your safety is specially the appliance are prohibited.
Special safety information for this Unit WARNING WARNING: NING: Danger from electrical current! Contact with live leads or components can be fatal! • The connection of the appliance must satisfy the relevant standards and regulations and may only be performed by an authorized specialist. • The appliance may not be used if the glass glass surface has cracks or is brobr ken. • The use of high-pressure pressure cleaners or steam cleaners is prohibited. InI gress of liquids can lead to electric shock.
• Make sure that with installing adequate air circulations ensured and the ventilation slots are not blocked. • Do not store any cleaning agents or flammable materials in the appliappl ance or in the immediate vicinity.
• Keep safety distances; sufficient air circulation Appliance Equipment must be ensured: Hob arrangement NOTE: NOTE: The listed power settings can vary depending on the material and/or size of the cookware.. 1 Control panel 2 Ø 13.5 cm / 1000 W A 760 mm B 50 mm C 20 mm (min) D Air intake 30 mm E Air outlet 5 mm Ø 23 cm / 2200 W 3 Ø 16.5 cm c / 1200 W 4 Ø 16.5 cm / 1100 W Preparing the worktop for installation of the hob CAUTION: 27 x 16.
Installing the hob • The appliance is suitable for three-phase three and AC current (220-240/380-415V 415V 3N~ 50/60Hz). • Fix the mains cable in the tension relief. • The electrical installation of the oven should be equipped with an emergency switch, which A B C D switches off the whole appliance from the mains Screw Bracket Drilling Hob bottom supply in an emergency.
Wrong! Wrong! 4 Child safety lock Cookware is too small. Button to activate/deactivate the child lock. Heat loss! 5 On/Off Cookware ground uneven. Button to switch the unit on and off. Poor heat transfer! 6 Timer Lid does not close properly. Button to select the timer functions. Heat loss! 7 Timer control Correct! To save time and and energy! Buttons to adjust the timer: Diameter of the cookware corresponds (+) time increase / (-) time decrease with the diameter of the hob.
Child safety lock • When the operation period of this cooking zone is elapsed, the display shows the remaining time of To protect againstt unwanted operation, the unit is the cooking zone for which the next shortest mam equipped with a lock function. turity was selected. Switch on the child lock. The timer display shows the NOTE: NOTE: activation with [Lo]. All buttons, except the on/off You can view the remaining time of another cooking button, are locked for operation. zone at any time.
Automatic switchswitch-off The diameter of the pot and pan floors should be according to the size of the cooking zone, or bigger. The automatic switch-off is a safety function for your Pans and pots, which are too small on the cooking appliance. If a cooking zone is in operation for a long zone lead to energy losses. Note: Dishes producer period and if you do not enter anything on the control partly indicate the upper pot diameter. It is usually panel, the automatic switch-off off will be activated.
CAUTION: CAUTION: NOTE: • Do not use a wire brush or other sharp, abrasive If a problem still persists after following the steps items. above, contact your distributor or an authorized techtec • Do not use harsh abrasive cleaners or sharp metme nician. al objects for cleaning. The glass surface can be scratched or destroyed. Technical Data • Always consider the application and safety notes Electrical connection...………………………………….. of the detergent. Connection voltage: ….
Information concerning erning where these can be disposed of can be obtained from your local authority. WARNING: Remove or disable any existing snap and bolt locks, if you take the unit out of operation or dispose it. Information to professional users for disassembly (acc. VO (EU) No. 66/2014 appendix I, No. 2) Hob / Induction hob Information for non-destructive destructive disassembly for maintenance purposes A further disassembly for maintenance purposes by the user is not provided.
EU Product data sheet Product information for domestic electric hobs according EU 66/2014 Position Symbol Value Brand BOMANN Model identification EBK 957.1 957.
www.bomannwww.bomann-germany.de Made in P.R.C. 16 Stand 12/18 C.
