Instructions

20
Maintenance of the hood
Maintenance of the hoodMaintenance of the hood
Maintenance of the hood
• To clean the surface of the housing, use a mild
detergent and a soft cloth to prevent scratching.
• The appliance can be used again after everything
has dried properly.
• If you use your cooker hood in recirculation mode,
you must replace the activated carbon filter regu-
larly (see “Replacing the activated carbon filter”).
Cleaning the aluminum grease filter
Cleaning the aluminum grease filterCleaning the aluminum grease filter
Cleaning the aluminum grease filter
WARNUNG: Risk of fire!
WARNUNG: Risk of fire!WARNUNG: Risk of fire!
WARNUNG: Risk of fire!
Grease residue in aluminum grease filter may ignite
at intense heat. Therefore, clean the grease filter
regularly!
We recommend cleaning the grease filter monthly:
• Remove the aluminum grease filter by sliding
back the lock in the handle recess, push the filter
down gently and pull out towards the front.
• Rinse the grease filter in a solution of hot water
and neutral detergent. Soak the filter in it.
• Then clean with a soft brush, rinse thoroughly with
hot water and allow drying.
• Alternatively, the grease filter can also be cleaned
in the dishwasher (up to 60°C). Slight discolora-
tion may occur. This does not affect the function
of the grease filter.
Replacing the activated carbon filter
Replacing the activated carbon filterReplacing the activated carbon filter
Replacing the activated carbon filter
The activated carbon filter prevent odors and must
depend on the use, but be changed at least every six
months.
Order the carbon filter from your dealer or in our
online accessories shop, www.bomann.de
www.bomann.dewww.bomann.de
www.bomann.de. Use the
reference number found under “Technical Data”.
• See “Installing the activated carbon filter for recir-
culation mode”.
• Remove the old carbon filter by turning the filter
anti-clockwise.
Replacing
ReplacingReplacing
Replacing the bulb
the bulbthe bulb
the bulb
WARNING:
WARNING:WARNING:
WARNING:
Allow the lamps to cool down before replacing the
bulbs. Risk of burns!
Risk of burns!Risk of burns!
Risk of burns!
NOTE
NOTENOTE
NOTE:
::
:
Oder the lamps from your dealer or in our online
accessories shop www.bomann.de
www.bomann.dewww.bomann.de
www.bomann.de.
L
LL
Lamp specification:
amp specification: amp specification:
amp specification: LED, 2 x
LED, 2 x LED, 2 x
LED, 2 x 2
22
2 W
WW
W
• Use the screwdriver on the edge of the LED light
to prize up it and pull the wire out slowly.
• When it is open, using the screwdriver prize up
the PCB box and separate the connector and
change it.
NOTE:
NOTE:NOTE:
NOTE:
The booster-function only works with increased pow-
er, after 7 minutes the power will reduced.
Troubleshooting
TroubleshootingTroubleshooting
Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialistBefore you contact an authorized specialist
Before you contact an authorized specialist
Problem
ProblemProblem
Problem Possible Cause / Solution
Possible Cause / SolutionPossible Cause / Solution
Possible Cause / Solution
Appliance is not
working or not
properly
- Check the power supply.
- Check the power level.
Appliance is not
working
efficiently
- Check the power level.
- Is the kitchen properly ventilated?
- Clean the grease filter.
- At recirculation mode, check the
carbon filter.
- Check the air outlet.
Light is not
working
Check the bulb, see “Replacing the
bulb”.
Oil is dripping Clean the grease filter.
NOTE:
NOTE:NOTE:
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.