Instructions

18
• Use 2 screws ST4*8 to fix outside chimney on the
hood, and then use screws ST4*40 to fix outside
chimney on the wall.
• Pull out the inside chimney and fix the chimney on
the wall.
For the extraction mode:
For the extraction mode:For the extraction mode:
For the extraction mode:
• Attach a flexible extraction hose (not
supplied) with an inner diameter of
Ø150 mm onto the connecting piece.
Installing the activated carbon
Installing the activated carbonInstalling the activated carbon
Installing the activated carbon filter for recirculation
filter for recirculation filter for recirculation
filter for recirculation
mode
modemode
mode
• Open the cover and remove the aluminum grease
filter.
• Place the carbon filter onto the air intake of the
extraction duct. Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
• Reinstall the aluminum grease filter and close the
cover.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
electric electric
electric
shock
shockshock
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
Information to reduce the environmental effect of
Information to reduce the environmental effect of Information to reduce the environmental effect of
Information to reduce the environmental effect of
cooking
cooking cooking
cooking
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
Cooker hood
Cooker hood Cooker hood
Cooker hood
The diameter of the pot and pan floors should be
according to the size of the cooking zone.
Use pans and pots with flat floors, uneven floors
increase the energy consumption.
Ensure that there is sufficient supply air for the oper-
ation of the cooker hood.
Adjust the fan step intensity of the damp evolution of
the cooking process.
To product the optimal effect of the cooker hood,
install it according to the installation instructions.
Keep the distance between the upper edge of the
cooker and the lower edge of the cooker hood.
Clean the filter regularly.
Controll the active carbon filter regularly and renew it
as required.
Switch off the cooker hood after use.
If your cooker hood has a switch-off delay, activate
this function.
Switch off the lighting after the cooking process.
We recommend the use of biological cleaners.