Specifications

69
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
Above, holes 1-4 are mirrored across the Y axis to 5-8, respectively, about a line X
OFFSET from X=absolute 0
ROTATE is used for polar rotation of parts that have a rotational symmetry around some
point in the XY plane. In addition to specifying the events to be repeated, you must also
indicate the absolute X and Y position of the center of rotation, the angle of rotation
(measured counterclockwise as positive; and clockwise as negative), and the number of
times the specified events are to be rotated and repeated. You may not rotate another
rotate event, however you can rotate a mirror event. Consider the figure below:
Shape A programmed with 4 MILL events and Conrads. Using ROTATE, these 4 events
are rotated through a 45 degree angle about a point offset from absolute zero by X Center
and Y Center dimensions. A is rotated 3 times to produce shape B, C, and D