Specifications

25
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
Limit Switch Cam Locations
Axis End
Location of Cam Bracket
Cam Location
X-axis Negative End
Left hand side of the table (front)
Upper channel
X-axis Positive End
Right hand side of the table (front)
Lower channel
Y-axis Negative End
On the base casting, beneath the saddle
(back)
Upper channel
Y-axis Positive End
On the base casting, beneath the saddle
(front)
Lower channel
Z-axis Negative End
On the column casting (upper)
Right hand channel
Z-axis Positive End
On the column casting (lower)
Left hand channel
ATC Home Position
Sensor
ATC shroud
Target bolt on the
carousel
ATC Sliding Body,
home
Bracket-Sliding Body Support, left
Sliding Body
ATC Sliding Body,
Advanced
Bracket-Sliding Body Support, right
Sliding Body
WARNING!
It is not recommended that the position of the limit switches be
changed. They are preset at the factory and should require no
additional adjustments. Should any major adjustments be required,
Service Codes 500, 501, 502 and 505 may need to be performed.
3.3.16 Lubrication System
The automatic lubricating system is a centralized system. It is located at the rear of the
machine. While the system is automatic, it is recommended that after long idle periods,
the machine be manually lubricated by pressing, holding (about five seconds) until the
system is charged, then releasing the square green button located on the lubricator, repeat
three to five times. The lubricating system delivers 2 shots of oil when the machine is
turned on at the disconnect switch, and 1 shot every 30 minutes while the machine is
running. The lubrication reservoir should be maintained on a daily basis, filling only
with high quality lubricating oil. All pneumatic components are lubricated by means of
an inline oiler.
3.3.17 Coolant and Coolant Wash System
The coolant and coolant wash system uses two pumps, one for providing coolant to the
work, and the other for washing the chips into the auger. Wash areas can be controlled by
the flexible coolant lines found at the base of the enclosure, both left and right-hand
sides. Coolant wash can also be done with the use of the hose and nozzle found on the
front exterior of the enclosure. The coolant feature must be turned on at the hard key on
the Run Panel.
The coolant tank holds approximately 55 gallons of coolant.