Specifications

Southwestern Industries, Inc.

TRAK LPM Programming, Safety, & Operating Manual

3.2.2 Run Panel

The Run Panel is the lower panel on the front of the pendant.

Spindle Keys

FWD: turns the spindle on in the forward direction in DRO Mode

OFF: turns the spindle off in the DRO Mode

REV: turns the spindle on in the reverse direction in the DRO mode

Feed Keys

GO: initiates axis motion in DRO Mode or during a stop condition in Run Mode

STOP: halts axis motion

Electronic Hand Wheel Keys

Electronic Hand Wheel: used to control X, Y, Z axis positioning, spindle rpm override,

and axis feed override. There are 100 positions or detents per revolution.

SPINDLE OVERRIDE: enables handwheel to control spindle rpm override from 0 to 150

percent in 2% increments.

FEED OVERRIDE: enables handwheel to control axis feed override from 0 to 150

percent in 2% increments.

EHW: enables handwheel to control positioning along X, Y, Z axes.

X, Y, Z: selects axis to be controlled by Electronic Handwheel.

.0001in / .002mm: selects incremental axis motion per handwheel detent. One revolution

equals (.0001in x 100) 0.01in.

.001in / .02mm: selects incremental axis motion per handwheel detent. One revolution

equals (.001in x 100) 0.1in.

.01in / .2mm: selects incremental axis motion per handwheel detent. One revolution

equals (.01in x 100) 1.0in.

FAST: selects fast axis motion for coarse movement up to 300 ipm.

Auxiliary Function Keys

COOLANT: press to turn coolant on (ON LED is lit). Press again to turn coolant on

(AUTO LED is lit) when commanded by the program in Run Mode. Press again to turn

coolant off.