Specifications

15
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
2. Go to the ProtoTRAK PMX CNC on which the option is to be installed, use Service
Code 318 to go to the Software Options Screen.
3. Highlight the option you wish to install and press the softkey labeled INSTALL.
4. A screen will appear that advises you how to purchase the option. Near the bottom of
the screen there will be a Hardware Key Serial Number and an Option Serial Number.
Write down both of these numbers.
5. Call your Southwestern Industries Sales Representative or the Southwestern Industries
Order Desk with your purchase order number and the numbers you wrote down in step 4
above.
6. When you receive your Password Activation Number, input it into the ProtoTRAK
where indicated on the screen obtained in step 2 above. Some options require you to
reboot the ProtoTRAK to activate.
7. Refer to the appropriate section of this manual for instructions on using your new
features.
3.2 Display Pendant
The display pendant is integrated into the TRAK LPM on the front right side of the
machine enclosure. The pendant may swing out 80º for your convenience and may be
locked in place at 45º and 80º.
3.2.1 Program Panel
The Program Panel is the upper panel on the front of the Pendant.
INC SET: loads incremental dimensions and general data
ABS SET: loads absolute dimensions and general data