Specifications

161
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
15.3.4 SET A
Press this button to set you A axis to a temporary abs value. Like the other axis, this is
only for the ABS reference, and does not affect your part’s abs 0 location.
15.3.5 REF 4
th
Axis
Press REF, and then 4
TH
AXIS to reference from the 4
th
axis. The reference points
referenced here are defined in service code 506. The X represents the distance to the
faceplate of the 4
th
axis. The Y and Z axis reference the center line of the 4
th
axis
rotation. The A axis will reference its machine home position.
15.4 PROG Mode
Once the fourth axis is turned on in MACH SETUP mode (see section XX), the software
will enable new programming options. Under the header event, set the Fourth Axis
Request parameter to YES. This will enable the new events discussed below.