Specifications

120
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
500
X, Y Ball Lock Offsets
Used to enter the offsets for ball locks A, B
and C
501
Set Z Tool Change Height
Used to enter the offset for the tool changer
height relative to the Z home position, and
to manually move the ATC in and out.
502
Set Base Tool Height
Used to set the base tool height relative to
the top of the table.
505
Over-travel Limits
Used to setup and troubleshoot software
limits. Also used to get machine off a limit
switch when over-traveled.
510
Spindle Setup
Used to calibrate spindle, orient the spindle
in relation to the ATC, and troubleshoot
any spindle encoder related issues.
Diagnostic Codes
54
Continuous Run Mode
Cycles through the program in current
memory.
81
Program Panel Keyboard Test
Gives a tone feedback to a button push and
highlights the button.
82
Run Panel Keyboard Test
Gives a tone feedback to a button push and
highlights the button.
131
Manual DRO
Turns off servo’s so you can check
encoders
132
Electronic Handwheel Test
Test the EHW signals
314
Toggle Test Lights in Status Line
Used to troubleshoot control issues
319
Error Logging
Logs the machine as it runs
326
Error Message Display
Displays error messages on screen
327
Display Memory Check
Displays memory availability of various
devices
Operator Defaults/Options
66
Metric Boot Up Default
To have the ProtoTRAK open up in mm
measurement.
67
English Boot Up Default
To have the ProtoTRAK open up in inch
measurement.
79
Turn On Beeper
Turn the beeper on when pressing keys on
either of the front panels
80
Turn Off Beeper
Turns the beeper off when pressing keys
503
Set Maximum Feedrate
Sets the rapid speed for the machine.
Default is 800 ipm
504
Set Part Change Position
Sets the part change position along the X
axis for auxiliary function 6.
507
Reset Servo Fault
Must be run when servo amp faults
508
Toggle S Curve On/Off
Changes acceleration and deceleration of
axes.
509
Select 4
th
Axis Type
Must be used to select the 4
th
axis design
type being used for a particular machine