Specifications

95
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
Any change made in the editor will be applied the next time you run the program. To
permanently save these changes, go to PROG IN/OUT screen and use the save feature.
10.6 Update GCD
The UPDATE GCD button will show up when a .PTG file is loaded into memory. This
feature allows you to update the G code file that is linked within the .PTG file. This is
useful when you go back to your offline computer and update your G code file and then
want to re-insert it into your .PTG file.
If you load just a .GCD file into memory, then this button will be grayed out until you
save the program as a .PTG file. A .PTG file is created when you save a G code file with
notes and pictures.
When using UPDATE GCD, you must first remove the link to the G code file that is in
your .PTG file. To do so, press the TAB softkey and highlight the file in question and
then press REMOVE ITEM as shown in the figure below.