User Manual

Mobile Camera MG582 4 Advanced Operations
Page 12
This parameter affects the number of pictures taken for each triggering in the
camera mode. It has three values: “1 Photo” “2 Photos” and “3 Photos”. Its default
value is “1 Photo”. The following shows how to set photo burst to 3 Photos, provided
that the previous option is 1 Photo:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Photo Burst.
c) Press LEFT or RIGHT to select 3 Images.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.8 Set Video Length
This parameter is effective and can be adjusted only when the device in the video
mode under ON mode. Its value extends from 1 to 60 seconds with a step of one
second. The default value is 10 seconds. Press LEFT and RIGHT to decreases or
increases the value by 1 second.
The following shows how to set video length to 5 Seconds provided that the
previous value is 10 Seconds:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Video Length.
c) Press LEFT or RIGHT to decrease or increase to 5 Seconds.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and exit.
4.1.9 Set Video Sound
The following shows how to set video sound as off that the previous option is on:
e) Press MENU to display the setting menu.
f) Press UP or DOWN to select Video Sound.
g) Press LEFT or RIGHT to select off or on.
h) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.10 Set PIR Triggering Interval Time
This parameter means that how long the PIR (Passive Infrared motion sensor)
will be disabled after each triggering in ON mode. During this time the PIR of the
device will not react to the motion of human (or animals). The minimum interval is 0
second, it means the PIR works all the time. The maximum interval is 1 hour. It
means the PIR will be disabled for 1 hour after each triggering. The default value is 1
minute. Press LEFT or RIGHT to decrease or increase the value by 5s or 1 minute.
The following shows how to set triggering interval time to 5 Minutes provided
that the previous value is 1 Minute.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Interval.
c) Press LEFT or RIGHT to decrease or increase to 5 Minutes.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.