User Manual

42
|
42
|
Using Wireless Multi (Stroboscopic) Mode
To cancel slave mode, press and hold the MODE button until the TTL mode indicator appears on the LCD.
Important! When using a single ash, set it to the same group and channel as the master.
When using multiple ash units, select the same group and channel for all units being used in a particular light
position. For example, if you are using three VX-760C units, you might want to set one as a main light on 1A,
set the second as a ll light on 1B, and set the third as a hair light on 1C. With this setup, you have the option
of setting each group to a different slave mode via the master ash. If desired, you can set the main on 1A to
TTL mode, the ll light on 1B as a ratio of 1A, and you may elect to disable the hair light on 1C.
Using Wireless Multi (Stroboscopic) Mode
The VX-760C can be used as a wireless TTL master unit in multi (stroboscopic) mode. In wireless multi mode,
the slaves can have different ash outputs, and the ash frequency and number of ashes will be the same for
the master and slave units.