User Manual

37Using the Multi (Stroboscopic) Mode

maximum number of ashes. When the desired stroboscopic count number appears on the LCD, press the

MODE button to select it.

3. Set the ring frequency by pressing the SUB button repeatedly until the stroboscopic frequency number

blinks. The frequency, measured in hertz (Hz), indicates the number of ashes per second. Use the left

and right navigation buttons to adjust the frequency, or the up and down navigation buttons for the

minimum and maximum frequencies. When the desired stroboscopic frequency number appears on the

LCD, press the MODE button to select it.

4. To determine the appropriate shutter speed, divide the stroboscopic count number (the number of ashes

per frame) by the stroboscopic frequency number (the frequency of the ash).

For example: If the number of ashes per frame is 10, and frequency of the ash is 5 Hz, then

10 ashes per frame

5 HZ

so the shutter speed should be 2 seconds or slower.

Note: See Stroboscopic Reference Chart on page 49 for the maximum number of ashes at any given power/

frequency combination.