User Manual

Using Flash Exposure Compensation

Flash exposure compensation lets you adjust and optimize your ash’s automated setting by increasing or

decreasing its light output without affecting the exposure as a whole.

In automatic TTL mode, you can use ash exposure compensation to adjust the VX-710N’s ash output

incrementally, just as you would adjust exposure with the exposure compensation function on your camera.

To apply ash exposure compensation, use the left and right navigation buttons to adjust by full stops, and

the up and down navigation buttons to ne-tune in increments of one-third. The ash exposure compensation

indicator will appear on the LCD.

Note: When decreasing ash exposure compensation in

increments of one-third from a whole stop, you will need to

decrease it by one whole stop, and then increase by two-thirds.

For example, when ne-tuning from +2 to +1⅔, you will need to

adjust the value to +1, and then ne-tune to +1⅔. When working

with negative numbers, e.g., when ne-tuning from -1 to -1⅓, you

will need to adjust the value to -2, and then ne-tune to -1⅓.

Zoom

ISO