User Manual

18
|
Turning on the Flash and Firing a Test
To turn on the audio monitor, press the AUDIO ( ) button. The audio icon ( ) will appear on the LCD, and the
ash will emit a beep. Repeat this step to disable the audio monitor. Note that the low battery warning will
sound even if the audio monitor is off.
Lock mode: To prevent inadvertent operation of your ash, you can lock it by setting it to lock mode. To lock
the device, press and hold the LOCK button ( ) until the lock icon ( ) appears on the LCD. Repeat this step to
unlock the device.
Important!
Make sure that slave mode is turned off when mounting the VX-710N on your camera. Turn it on only when
using the ash as an off-camera wireless slave.
Overheating protection mode: If the operating temperature of the VX-710N is too high, or after 25 continuous
ashes at 1/1 (full power), the ash will enter overheating protection mode. The thermal warning icon (
) will
appear on the LCD, the unit will emit a long beep for over ten seconds, and you will be unable to re a ash.
We suggest you turn the unit off for ten minutes to let it cool down.