User Manual

Troubleshooting
|
41
Problem Solution
The ash is set up as a wireless
slave, but the light is not
noticeable in the picture.
• Make sure that the master ash is within the transmission range, and
that the wireless sensor on the slave is pointing toward the master
ash. Remove any obstructions in the line of sight between the two.
(Page 38)
• Make sure that the ash is set to the appropriate slave mode. (Page
37)
• The ambient light may be too high. (Page 39)
The edges of the images look
dark.
• Make sure that the ash zoom setting corresponds to the focal length
of your lens. (Page 27)
• Your lens is wider than 24mm. Use the built-in wide-angle diffuser.
(Page 30)
The bottom of the images look
dark.
• To fully illuminate your subject when shooting close-up photography,
tilt the ash down to the -7° position. (Page 31)
• Your camera’s shutter speed is higher than its max sync speed in
manual mode. Use a slower shutter. (Page 26)