User Manual

Using the Manual Flash Mode

You can set the VX-710C’s ash output level manually, for greater creative control over your images. The 1/1

setting is the full-power ash, and each successive setting halves the light output, all the way down to 1/128.

You can also ne-tune the ash output in increments of one-third.

To use the manual mode, turn the ash and camera on and follow these steps:

1. Press the MODE button repeatedly to cycle through the ash modes until the manual mode indicator and

the ash output level appear on the LCD. Use the left and

right navigation buttons to set the ash output, and the up

and down navigation buttons to ne- tune.

2. Set the exposure settings you want to use on your camera.

3. Press your camera’s shutter-release button to take the

picture.

4. Adjust your camera’s exposure settings and the light

output level of the ash as needed.

Zoom

ISO