User Manual

Troubleshooting
|
29
Problem Solution
The ash is set up as a wireless
slave, but the light is not
noticeable in the picture.
• Make sure that the master ash is within the transmission range,
and that the wireless sensor on the slave is pointing toward the
master ash. Remove any obstructions in the line of sight between
the two (page 24).
• The ambient light may be too high (page 24).
The edges of the images
look dark.
Make sure that the ash output power setting corresponds to the focal
length of your lens.
The bottoms of the images
look dark.
Your camera’s shutter speed is higher than the ash’s maximum sync
speed in manual mode.