User Manual

Stroboscopic Mode

2. Press the Set button to highlight the ash output power level, and adjust with the right and left arrows.

3. Press the Set button to conrm.

4. Press the F1 function button to change the Time. This will set the number of ashes that re per

exposure. Use the right and left arrows to adjust the amount.

5. Press the Set button to conrm.

6. Press the F2 function button [Hz] to change the frequency, or the number of ashes per second. Use the

right and left arrows to adjust.

7. To conrm your settings, press the Set button.

8. Set your camera’s shutter speed to one second or slower.

9. Press the shutter button to re a test shot. The ash will re several bursts of light.

Tip: To calculate the appropriate shutter speed, divide the number of ashes per frame by the frequency.

For example, if the number of ashes per frame is 10, and the frequency of the

ash is 5 Hz, then the shutter speed should be 2 seconds or slower.

Note: See Stroboscopic Reference chart on (page 26) for the maximum number of ashes at various power/

frequency combinations.

10 ashes per frame

5 Hz