User Manual
16
|
Using Flash Exposure Compensation
3. Press the shutter release button on your camera halfway to ensure that the camera is communicating
with the ash. The camera’s aperture settings will appear on the ash LCD, and a ash icon will appear in
the camera’s viewnder.
4. Press your camera’s shutter release button to take the picture.
Using Flash Exposure Compensation
Flash exposure compensation allows you to adjust and optimize your ash’s automated setting by increasing
or decreasing its light output without affecting the exposure as a whole.
In automatic TTL mode, you can use ash exposure compensation to incrementally alter the VC-310’s ash
output, just as you would change exposure with the exposure compensation function on your camera.
To apply ash exposure compensation, follow these steps:
1. VC-310F and VC-310OP: Press the Set button so that the ash exposure compensation value is
highlighted and appears on the LCD.
VC-310SMI: Press the Set button so that the ash exposure compensation value blinks.
2. Use the left or right arrows to adjust the exposure compensation from -3 to +3 stops, in increments of
one-third.
3. Press the Set button to conrm the value.